Rohde & Schwarz SMW200A - How to Enable Signals and Perform Signal to Connector Mapping

General Instrument Functions
R&S
®
SMW200A
677User Manual 1175.6632.02 ─ 16
Threshold Clock/Trigger Input
Sets the high/low threshold in volts for the trigger and clock signal inputs of the base-
band section.
Remote command:
[:SOURce<hw>]:INPut:TM:CLOCk:LEVel on page 863
[:SOURce<hw>]:INPut:TM:TRIGger:LEVel on page 863
Impedance Clock/Trigger Input
Selects the input impedance for the external trigger/clock inputs.
Remote command:
[:SOURce<hw>]:INPut:TM:CLOCk:IMPedance on page 863
[:SOURce<hw>]:INPut:TM:TRIGger:IMPedance on page 863
Clock Input Slope
Sets the polarity of the active slope of an externally applied clock signal.
Remote command:
[:SOURce<hw>]:INPut:TM:CLOCk:SLOPe on page 864
Trigger Input Slope
Sets the polarity of the active slope of an externally applied trigger signal.
Remote command:
[:SOURce<hw>]:INPut:TM:TRIGger:SLOPe on page 864
11.2.7 How to Enable Signals and Perform Signal to Connector Mapping
This section introduces the general principle of connector configuration.
General Workflow
The Figure 11-2 shows the main configuration stages, together with the corresponding
user interface dialogs.
Figure 11-2: The principle of the signal to connector mapping
To perform the signal to connector mapping, perform the following:
1. Verify the current connector configuration and mapping and if required (re)define it.
2. Configure and enable the required signal, e.g. trigger, marker, clock signal.
Configuring the Local and Global Connectors