Maintenance
R&S
®
SMW200A
1154User Manual 1175.6632.02 ─ 16
14.3.1 Date and Time Settings
The R&S SMW uses an internal real-time clock to determine the date and time. It
adjusts the time and date to the timezone of your location automatically, by providing a
selection list of continents and cities.
The instrument records the time whenever you create or modify files on your instru-
ment or you use timed licenses.
In addition, the instrument supports NTP (Network Time Protocol) for synchronizing all
connected instruments and computer systems to minimize time delays in the network.
You can see the current date and time as follows:
► Select "System Config > Setup > Maintenance > Date / Time".
The "Date / Time" dialog contains the time and data settings of the operating sys-
tem.
This function is password-protected. Unlock the protection level 1 to access it, see
"Protection Level/Password" on page 688.
To set the date and time, proceed as described in "To set the date and time"
on page 50.
The required remote commands are described in Chapter 13.19, "SYSTem Subsys-
tem", on page 1115.
Date
Displays the date set in the operating system in the format [dd.mm.yyyy].
Remote command:
:SYSTem:DATE on page 1133
Performing Maintenance Tasks
To Next Page
Loading...
