Rohde & Schwarz SMW200A - Defining the RF Signal State on Power on

General Instrument Functions
R&S
®
SMW200A
660User Manual 1175.6632.02 ─ 16
Display Update is
Disables the automatic refreshing of the displayed values.
Remote command:
:DISPlay:UPDate on page 798
11.1.4 Defining the RF Signal State On Power On
As additional functions for the level settings, you can determine the state of the RF sig-
nal, and the level display in the status bar when you turn on the R&S SMW.
Power-On/EMF settings
Access:
► Select "RF" > "RF Level" > "Power-On / EMF".
The "Power-On/EMF" dialog contains all settings for configuring the power-on
behavior and the level display.
Settings:
Power-On State ..........................................................................................................660
Display Level as Voltage of EMF ............................................................................... 660
Power-On State
Determines the RF signal output state when the instrument is switched on.
You can disable the RF output signal in general, or start it in the same state as it had
been when it was switched off.
Remote command:
:OUTPut<hw>[:STATe]:PON on page 809
Display Level as Voltage of EMF
Activates display of the signal level as voltage of the EMF (no-load voltage).
If disabled, the level is displayed as a voltage over a 50 Ohm load.
Note:
Customizing the User Interface