Rohde & Schwarz SMW200A - Display Subsystem

Remote Control Commands
R&S
®
SMW200A
796User Manual 1175.6632.02 ─ 16
Return values:
<BgInfo> <Module name> <Module stock number incl. variant> <Module
revision> <Module serial number>
List of comma-separated entries, one entry per module.
Each entry for one module consists of four parts that are separa-
ted by space characters.
Example: See Example "Programming example" on page 795.
Usage: Query only
Manual operation: See "Assembly" on page 1168
:DIAGnostic<hw>:POINt:CATalog?
Queries the test points available in the instrument.
For more information, see R&S SMW Service Manual.
Return values:
<Catalog> string
List of comma-separated values, each representing a test point
Example: See Example "Programming example" on page 795.
Usage: Query only
:DIAGnostic<hw>[:MEASure]:POINt? <Name>
Triggers the voltage measurement at the specified test point and returns the measured
voltage.
For more information, see R&S SMW Service Manual.
Query parameters:
<Name> <test point identifier>
Test point name, as queried with the command :
DIAGnostic<hw>:POINt:CATalog?
Return values:
<Value> <value><unit>
Example: See Example "Programming example" on page 795.
Usage: Query only
13.11 DISPlay Subsystem
The DISPlay system contains the commands to set the power-save mode of the
instrument.
DISPlay Subsystem