Signal Routing and System Configuration
R&S
®
SMW200A
148User Manual 1175.6632.02 ─ 16
Access:
► Select "Taskbar > System Config > System Configuration > External RF and I/Q".
The dialog provides an overview of all available I/Q input and output connectors
and comprises the settings necessary to establish the connection to the external
instruments. Displayed is an overview of the currently connected external instru-
ments together with relevant information like the connection status and the RF
level and frequency these external instruments use.
The dialog provides access to some additional short information on each of the
connected instruments. It also provides a show connector function for an easy
localization of the selected connector on the instrument front and/or rear panel.
For step-by-step description on how to use the provided settings, refer to:
●
Chapter 3.9.5, "How to Cable the Instruments in MIMO Test Setups", on page 197
●
Chapter 3.9.6, "How to Connect and Configure External Instruments", on page 198
Settings:
● Connections Configuration and Connection Status Overview Settings................ 148
● External Instrument Configuration Settings...........................................................154
3.4.3.1 Connections Configuration and Connection Status Overview Settings
Access:
► Select "Taskbar > System Config > System Configuration > External RF and I/Q".
System Configuration Settings
To Next Page
Loading...
