Rohde & Schwarz SMW200A - Hard Copy Settings

Remote Control Commands
R&S
®
SMW200A
804User Manual 1175.6632.02 ─ 16
// queries the path and file name of the automatically generated file
// response: "/usb/HCopy/hardcopy1607001.bmp"
13.13.2 Hard Copy Settings
With the following commands, you can configure the settings of a hard copy.
:HCOPy:DATA?.............................................................................................................804
:HCOPy:IMAGe:FORMat................................................................................................ 804
:HCOPy:DEVice:LANGuage............................................................................................804
:HCOPy:REGion............................................................................................................ 804
:HCOPy:FILE[:NAME].....................................................................................................805
:HCOPy[:EXECute]........................................................................................................ 805
:HCOPy:DATA?
Transfers the hard copy data directly as a NByte stream to the remote client.
Return values:
<Data> block data
Example: See Example "Store a hard copy of the display" on page 803
Usage: Query only
:HCOPy:IMAGe:FORMat <Format>
:HCOPy:DEVice:LANGuage <Language>
Selects the graphic format for the hard copy. You can use both commands alterna-
tively.
Parameters:
<Language> BMP | JPG | XPM | PNG
*RST: PNG
Example: See Example "Store a hard copy of the display" on page 803
Manual operation: See "Format" on page 652
:HCOPy:REGion <Region>
Selects the area to be copied.
You can create a snapshot of the screen or an active dialog.
Parameters:
<Region> ALL | DIALog
*RST: ALL
Example: See Example "Store a hard copy of the display" on page 803
Manual operation: See "Region" on page 653
HCOPy Subsystem