Configuring the Signal in the RF Domain
R&S
®
SMW200A
515User Manual 1175.6632.02 ─ 16
See also Table 11-1 in Chapter 11.2.2.1, "Global Connectors", on page 662.
7.7.3.6 Pulse Generator
► To access this dialog, select "RF > Analog Modulation > Pulse Generator".
Figure 7-23: Pulse Generator
The "Pulse Generator" tab contains the settings for creating the pulse modulation
signal internally.
Pulse Mode
Sets the operating mode of the pulse generator. Depending on the selection, the
instrument displays the associated parameters.
"Single"
Generates a single pulse in one pulse period.
"Double"
Generates two pulses in one pulse period.
Remote command:
[:SOURce<hw>]:PULM:MODE on page 884
Pulse Period
Sets the repetition rate of the generated pulse signal.
Analog Modulations
To Next Page
Loading...
