Rohde & Schwarz SMW200A - Check Front Panel

Maintenance
R&S
®
SMW200A
1155User Manual 1175.6632.02 ─ 16
Time
Displays the time set in the operating system in the format [hh.mm.ss].
The time setting corresponds to the selected Use Time from NTP Server.
Remote command:
:SYSTem:TIME on page 1134
Timezone
Selects the timezone.
You can select the timezone according to the major cities on the respective continents.
Note: By typing the first letter, you can quickly navigate through the lists to find the
desired destination.
Remote command:
:SYSTem:TIME:ZONE on page 1135
:SYSTem:TIME:ZONE:CATalog? on page 1135
NTP Address
Sets the IP address or host name of the NTP server.
NTP is a network time protocol used for synchronizing all participating devices in a
data network.
You can select a high-precision time server to reduce the impact of varying network
delays.
Remote command:
:SYSTem:NTP:HOSTname on page 1134
Use Time from NTP Server
Activates clock synchronization of the network via the NTP protocol.
Remote command:
:SYSTem:NTP:STATe on page 1134
14.3.2 Check Front Panel
With the functions provided in this dialog, you can verify the functionality of the control
keys and the touchscreen.
For Instructions on how to perform the tests and the expected results, see Chap-
ter 14.3.2.2, "How to Perform the Front Panel Tests", on page 1156
In case of malfunctions:
Contact the Rohde & Schwarz customer support, see Chapter 15.6, "Collecting Infor-
mation for Technical Support", on page 1177.
Accessing the online help in the check front panel dialog or exiting via ESC
During the test, the actual functions of all keys are disabled, including the HELP and
the ESC keys.
Performing Maintenance Tasks