Rohde & Schwarz SMW200A - F Available Tutorial Files

Available Tutorial Files
R&S
®
SMW200A
1243User Manual 1175.6632.02 ─ 16
F Available Tutorial Files
The R&S SMW provides a set of tutorials embedded in the software. The tutorials are
interactive examples and demonstrations on how to perform specific tasks.
This section lists the tutorial files supplied with the R&S SMW.
For information on how to access, start and work with the tutorials, follow the instruc-
tions listed in Chapter 2.5.6.1, "Using the Tutorials", on page 118.
Tutorial Type Tutorial Name Goal
First steps with the
R&S SMW
01_UnmodulatedSignal
Generating a simple unmodulated signal
02_DigitallyModulatedSignal
Generating a simple WCDMA-3GPP (QPSK 45°Offset)
signal with the help of the "Custom Digital Modulation"
functionality
03_ExternalTriggerSignal
Understanding the general principle of external trigger-
ing
04_MarkerSignal
Understanding the principle of marker signal generation
05_SignalRouting
Get started with signal routing
06_VisulalizeSignal
Verifying the generated signal with the graphics display
07_SaveRecallSettings
Storing instrument configuration to restore measure-
ments results later
08_LTESignal_Basics
Generating a simple LTE signal to get familiar with the
settings and configuration principle common for the digi-
tal standards
09_MIMO_GettingStarted
Shows how to use coupled baseband sources and
select a suitable fading and baseband configuration to
generate an EUTRA/LTE signal in 2x2 MIMO configura-
tion
Get started with base-
band power measure-
ments
90_BBPowerMeas_ContAcquisition
Using the continuous acquisition mode to analyze a
continuous WLAN 802.11 signal
91_BBPowerMeas_GatedAcquisition
Using the gated acquisition mode to analyze a particular
part of a burst WLAN 802.11 signal
92_BBPowerMeas_
MultiGatedAcquisition
Using the multi-gated acquisition mode to analyze a
particular part of a burst WLAN 802.11 signal
Advanced Configura-
tion Tasks
30_LTE_CA_2x2MIMO_CrossSched
Generating an 2x2x2 LTE-A signal with two component
carriers (intra-band carrier aggregation with cross-car-
rier scheduling) and 2x2 MIMO each carrier
40_ArbMultiSegmentSignal
Create a multi-segment waveform.
99_DefineUserKeyActions
Assigning action to the USER key