Network Operation and Remote Control
R&S
®
SMW200A
719User Manual 1175.6632.02 ─ 16
12.4.3 GPIB Address Settings
Access:
1. Select "System Config > Remote Access > GPIB Address".
2. Set the GPIB channel address of the connected instrument.
Remote command:
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess on page 1124
12.4.4 RS232 Settings
Remote control via a serial interface is possible via a USB. The controller and the
instrument must be connected with the external USB/serial-adapter R&S TS1-USB
(see recommended extras in the data sheet) and a serial crossover (null modem)
cable. A USB connection requires the VISA library to be installed on the controller.
VISA detects and configures the R&S SMW automatically when the USB connection is
established.
Access:
► Select "System Config > Remote Access > RS232".
In the "RS232" dialog, you can configure the settings of the serial interface.
The remote commands required to configure the settings remotely are described in
Chapter 13.19, "SYSTem Subsystem", on page 1115.
Remote Access Settings
To Next Page
Loading...
