Rohde & Schwarz SMW200A - Generating a Linear Slope Ramp Waveform

Configuring the Internal Baseband Source
R&S
®
SMW200A
382User Manual 1175.6632.02 ─ 16
Parameter Value
Marker
Channel 1...4 Restart
Clock
Source Internal
Multichannel Setup
Start Carrier 0
Stop Carrier 0
State on
Power 0 dB
Power Step 0 dB
Initial Phase 0°
Phase Step 0°
Channel Setup
State ON
Phase 0°
Power 0 dB
4.11 Generating a Linear Slope Ramp Waveform
Generating a linear slope ramp waveform with the baseband generator is a function
that requires the additional option Baseband Power Sweep (R&S SMW-K542). The
main application field of these signals is amplifier tests, e.g. to determine the 1 dB
compression point of an amplifier.
See user manual R&S
®
SMW-K542 Baseband Power Sweep.
4.12 Shifting and Boosting the Baseband Signal
The R&S SMW provides settings to frequency offset or power boost the baseband sig-
nals (internally generated and externally supplied) relative to the signals of the other
baseband sources.
Shifting and Boosting the Baseband Signal