Rohde & Schwarz SMW200A - Source:bb:graphics Subsystem

Remote Control Commands
R&S
®
SMW200A
1015User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:BB:IMPairment:OPTimization:MODE <Mode>
Sets the optimization mode.
Option: R&S SMW-K544
The value selected here is used also as optimization mode for the user-defined fre-
quency response corrections, and vice versa.
See user manual R&S
®
SMW-K544 User-Defined Frequency Response Correction.
Parameters:
<Mode> FAST | QHIGh | QHTable
FAST
Optimization by compensation for I/Q skew.
QHTable
Enabled if R&S SZU is connected to the R&S SMW and the con-
nection is active.
Improved optimization by maintained speed.
QHIGh
Optimization by compensation for I/Q skew and frequency
response correction.
This mode interrupts the RF signal. Do not use it in combination
with the uninterrupted level settings and strictly monotone
modes RF level modes (see [:SOURce<hw>]:POWer:
LBEHaviour on page 1097)
*RST:
FAST (R&S SMW-B10) / QHIGh (R&S SMW-B9) /
QHTable (if R&S SZU connected to R&S SMW and
the connection is active)
Example:
SOURce1:IQ:SOURce BASeband
SOURce1:BB:IMPairment:OPTimization:MODE FAST
Manual operation: See "Optimization Mode" on page 421
13.18.4.8 SOURce:BB:GRAPhics Subsystem
This subsystem contains the commands used to setup the graphical display.
Required options
See Chapter 8.1.1, "Required Options", on page 559
[:SOURce<hw>]:BB:GRAPhics:MODE........................................................................... 1016
[:SOURce<hw>]:BB:GRAPhics:SRATe:MODE................................................................1016
[:SOURce<hw>]:BB:GRAPhics:SRATe:USER.................................................................1016
[:SOURce]:BB:GRAPhics:CLOSe.................................................................................. 1017
[:SOURce]:BB:GRAPhics:ADD......................................................................................1017
[:SOURce]:BB:GRAPhics:SOURce................................................................................1017
[:SOURce]:BB:GRAPhics:SOURce:MUX........................................................................1018
SOURce Subsystem