Rohde & Schwarz SMW200A - Graphical Signal Display Settings

Monitoring Signal Characteristics
R&S
®
SMW200A
572User Manual 1175.6632.02 ─ 16
Remote command:
[:SOURce]:BB:GRAPhics:CLOSe on page 1017.
Note, that this command closes all graphical signal displays.
8.1.4 Graphical Signal Display Settings
Access:
1. Select "Taskbar > System Config > Graphics > Add".
2. Double click the thumbnail in the taskbar.
Figure 8-10: Graphical signal display of a power spectrum, zoomed in with markers
This section focuses on the functions of the enlarged graphical signal displays.
Settings:
Configure.....................................................................................................................573
Stop / Run................................................................................................................... 573
Zoom out.....................................................................................................................573
Reference Curves....................................................................................................... 573
Display Units............................................................................................................... 573
Show / Hide marker.....................................................................................................573
Reference Curve.........................................................................................................573
Displaying Baseband Signal Characteristics in Real-Time