Rohde & Schwarz SMW200A - Display and Keyboard Settings

General Instrument Functions
R&S
®
SMW200A
657User Manual 1175.6632.02 ─ 16
Start / stop display update
The operating system of the R&S SMW refreshes the displayed settings by default in
almost real-time, to keep the display updated with the internally used values. However,
you can turn off this function to reduce settling times when the instrument is remote
controlled.
We recommend that you switch off the display update for optimum sweep performance
with short dwell times and for fast settling times.
Consider that in this case the displayed values can differ from the operated values.
In detail described in the following paragraphs, you can:
●
Set display and keyboard language, see Chapter 11.1.1, "Display and Keyboard
Settings", on page 657
●
Customize the GUI appearance, see Transparency adjustment and Chap-
ter 11.1.2, "GUI Appearance Settings", on page 659
●
Set date and time for the system clock, see Chapter 14.3.1, "Date and Time Set-
tings", on page 1154
●
Configure and activate aScreen Saver
●
Deactivate display update to improve performance, see Chapter 11.1.3, "Display
Update Settings", on page 659
●
Determine the state of the RF signal, and the level display in the status bar when
you turn on the R&S SMW, see Chapter 11.1.4, "Defining the RF Signal State On
Power On ", on page 660.
The instructions in Chapter 2.1.5, "Configuring the Initial Instrument Settings",
on page 49 show you how to perform the settings in detail.
11.1.1 Display and Keyboard Settings
Access:
► Select "System Config > Setup > User Interface > Display or Keyboard".
Customizing the User Interface