Rohde & Schwarz SMW200A - Kboard Subsystem

Remote Control Commands
R&S
®
SMW200A
808User Manual 1175.6632.02 ─ 16
13.14 KBOard Subsystem
The KBOard subsystem contains the commands to set a connected keyboard.
:KBOard:LAYout............................................................................................................ 808
:KBOard:LAYout <Layout>
Selects the language for an external keyboard and assigns the keys acccordingly.
Parameters:
<Layout> CHINese | DANish | DUTCh | DUTBe | ENGLish | ENGUK |
FINNish | FRENch | FREBe | FRECa | GERMan | ITALian |
JAPanese | KORean | NORWegian | PORTuguese | RUSSian |
SPANish | SWEDish | ENGUS
*RST: n.a. (factory preset: ENGLish)
Example:
:KBOard:LAYout US
// activates American keyboard
Manual operation: See "USB Keyboard > Layout" on page 658
13.15 OUTPut Subsystem
In the OUTPut subsystem, you can configure the output signals.
The LF output signal is defined with the commands of the Chapter 13.18.10,
"SOURce:LFOutput Subsystem", on page 1061 system.
Common suffixes
The following common suffixes are used in remote commands:
Suffix Value range Description
OUTPut<hw>
[1] | 2 Signal path
:OUTPut:ALL[:STATe].................................................................................................... 809
:OUTPut<hw>[:STATe]...................................................................................................809
:OUTPut<hw>[:STATe]:PON...........................................................................................809
:OUTPut<hw>:AMODe................................................................................................... 809
:OUTPut<hw>:BLANk:LIST:STATe..................................................................................810
:OUTPut<hw>:IMPedance?.............................................................................................810
:OUTPut<hw>:AFIXed:RANGe:LOWer?...........................................................................811
:OUTPut<hw>:AFIXed:RANGe:UPPer?............................................................................811
:OUTPut<hw>:PROTection:CLEar................................................................................... 811
:OUTPut<hw>:PROTection:STATe.................................................................................. 811
:OUTPut<hw>:PROTection:TRIPped?..............................................................................811
OUTPut Subsystem