Configuring the Internal Baseband Source
R&S
®
SMW200A
309User Manual 1175.6632.02 ─ 16
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WAVeform:SELect on page 932
Waveform Info
Opens a dialog with detailed information about the currently selected waveform. The
display depends on whether the selected waveform file is a multi-segment one or not.
All parameters are read-only.
Remote command:
For non-multi segment waveform files, use the Tag commands (see Chapter 13.18.4.4,
"Waveform, Data and List Format", on page 961).
Clock Frequency
Displays or sets the ARB output clock rate.
The value of this parameter is set to the clock rate defined in the loaded waveform file
({CLOCK} tag). The value can be changed afterwards.
Note: The clock frequency must match the value of the externally applied clock source.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CLOCk on page 934
Delay
When Coupled sources are used, all basebands are triggered with a common trigger
signal.
Enable a time delay to delay the waveform processing of a particular baseband.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:COUPled:TRIGger:DELay:OFFSet
on page 935
Create Multi Segment
Accesses the dialog for creating multi-segment waveforms (see Chapter 4.8, "Generat-
ing Multi-Segment Waveform Files", on page 324).
Using the Arbitrary Waveform Generator (ARB)
To Next Page
Loading...
