Rohde & Schwarz SMW200A - Input Level Settings

Signal Routing and System Configuration
R&S
®
SMW200A
175User Manual 1175.6632.02 ─ 16
3.6.3 Input Level Settings
Access:
► Select "BB Input > Digital I/Q In > Baseband Input Settings > Input Level".
Settings:
DIG IQ Auto Setting.................................................................................................... 175
Measurement Period...................................................................................................176
Auto Level Set.............................................................................................................176
Crest Factor................................................................................................................ 176
Peak Level.................................................................................................................. 176
Level............................................................................................................................176
DIG IQ Auto Setting
Activates an automatic adjustment of the baseband input signal.
The R&S SMW receives PEP, level and crest factor values directly from the connected
transmitter and recognizes changes automatically.
Remote command:
[:SOURce<hw>]:BBIN:DIGital:ASETting:STATe on page 867
Digital Baseband Input Settings