Signal Routing and System Configuration
R&S
®
SMW200A
144User Manual 1175.6632.02 ─ 16
The pair of streams created out of the same baseband are identical, in terms of con-
tent, power level and frequency. The streams are treated as individual streams in
terms of adding AWGN and shifting within the available RF bandwidth.
This feature is useful, if your test setup requires a combination of max 4 signals with
real-time data source and 4 ARB signals. For example, for performing GSM AM sup-
pression tests according to 3GPP TS 51.021, chapter 8.
See user manual R&S
®
SMW-K550 Stream Extender.
Remote command:
:SCONfiguration:DUPLicate[:STReam] on page 839
Apply
Triggers the instrument to adopt the selected configuration.
Note: The RF outputs are disabled, if you apply new System Configuration LxMxN
and/or change the Baseband Source Configuration.
Remote command:
:SCONfiguration:APPLy on page 839
Ok
Applies the configuration and exits the dialog.
Remote command:
:SCONfiguration:APPLy on page 839
3.4.2 I/Q Stream Mapper Settings
Access:
► In the block diagram, select "I/Q Stream Mapper".
Figure 3-5: Example: I/Q Stream Mapper settings in a LxMxN configuration with four streams
System Configuration Settings
To Next Page
Loading...
