Rohde & Schwarz SMW200A - LF Generator Settings

Remote Control Commands
R&S
®
SMW200A
1063User Manual 1175.6632.02 ─ 16
13.18.10.1 LF Generator Settings
With the commands described in this section, you can configure the LF signal source.
[:SOURce]:LFOutput<ch>:BANDwidth?..........................................................................1063
[:SOURce<hw>]:LFOutput<ch>:FREQuency...................................................................1063
[:SOURce<hw>]:LFOutput<ch>:PERiod?........................................................................1064
[:SOURce<hw>]:LFOutput:FREQuency:MANual............................................................. 1064
[:SOURce<hw>]:LFOutput:FREQuency:MODE............................................................... 1065
[:SOURce<hw>]:LFOutput:FREQuency:STOP................................................................ 1065
[:SOURce<hw>]:LFOutput:FREQuency:STARt............................................................... 1065
[:SOURce]:LFOutput<ch>:OFFSet.................................................................................1065
[:SOURce]:LFOutput<ch>:SOURce............................................................................... 1066
[:SOURce]:LFOutput<ch>:SOURce:PATH......................................................................1066
[:SOURce]:LFOutput<ch>[:STATe]................................................................................ 1066
[:SOURce]:LFOutput<ch>:VOLTage.............................................................................. 1067
[:SOURce]:LFOutput<ch>:INTernal:VOLTage................................................................. 1067
[:SOURce<hw>]:LFOutput<ch>:SHAPe..........................................................................1067
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:DCYCle..................................................1068
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:PERiod...................................................1068
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:WIDTh....................................................1068
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:FALL.................................................. 1068
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:HIGH..................................................1069
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:PERiod............................................... 1069
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:RISE.................................................. 1069
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRIangle:PERiod................................................1069
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRIangle:RISE................................................... 1070
[:SOURce]:LFOutput<ch>:BANDwidth?
Queries the bandwidth of the external LF signal.
Return values:
<Bandwidth> BW0M2 | BW10m
*RST: BW10m
Example:
LFO:BAND?
// BW10m
// the bandwidth of the externally supplied LF signal is 10 MHz
Usage: Query only
Manual operation: See "Bandwidth" on page 505
[:SOURce<hw>]:LFOutput<ch>:FREQuency <Frequency>
Sets the frequency of the LF signal in [:SOURce<hw>]:LFOutput:FREQuency:
MODE CW|FIXed mode.
Note:
●
If the LF generator is used as a signal source, the instrument performs the analog
modulations (AM/FM/ΦM/PM) with this frequency.
SOURce Subsystem