Rohde & Schwarz SMW200A - ARB Settings

Configuring the Internal Baseband Source
R&S
®
SMW200A
305User Manual 1175.6632.02 ─ 16
4.7.3 ARB Settings
Access:
► Select "Baseband > ARB".
The "ARB" dialog enables direct selection of the waveform file to be processed, the
selection of a test signal or access to the multi-segment and multi-carrier settings.
If the current instrument configuration uses Coupled sources, you can assign
waveforms to all available basebands.
The dialog is divided into several tabs. In each case, the current setting is dis-
played in the tab name.
The remote commands required to define these settings are described in Chap-
ter 13.18.4.3, "SOURce:BB:ARBitrary Subsystem", on page 919.
Settings:
● ARB General Settings...........................................................................................305
● Sine Test Signals.................................................................................................. 311
● Rectangular Test Signal........................................................................................312
● Constant IQ Test Signal........................................................................................314
● Trigger, Marker and Clock Setting........................................................................ 315
4.7.3.1 ARB General Settings
Access:
► Select "Baseband > ARB".
This tab provides access to the default ARB settings, selecting a waveform file and
enabling the ARB generator.
Further settings depend on selected "System Configuration" and waveform type:
●
If a single segment waveform is used, the tab provides also settings for configuring
the test signal and access to the settings for calculating a multi-segment or a multi-
carrier waveform.
●
If a multi-segment waveform is loaded, the tab expands and displays the dedicated
section "Multi Segment Waveform Options".
Using the Arbitrary Waveform Generator (ARB)