Rohde & Schwarz SMW200A - Source:power Subsystem

Remote Control Commands
R&S
®
SMW200A
1092User Manual 1175.6632.02 ─ 16
Example: See Example "Programming Example" on page 1091.
Usage: Event
Manual operation: See "Reset Delta Phase Display" on page 440
13.18.15 SOURce:POWer Subsystem
The SOURce:POWer subsystem contains the commands for setting the output level,
level control and level correction of the RF signal.
The default units are dBm. To change the units, perform on of the following:
●
Enter the unit after the numerical value
Example: :POW 0.5V
●
Set the unit with the command :UNIT:POWer.
[:SOURce<hw>]:POWer:ALC:DAMPlifier........................................................................1092
[:SOURce<hw>]:POWer:ALC:DSENsitivity..................................................................... 1093
[:SOURce<hw>]:POWer:ALC:OMODe........................................................................... 1093
[:SOURce<hw>]:POWer:ALC:SEARch...........................................................................1094
[:SOURce<hw>]:POWer:ALC:SLEVel............................................................................ 1094
[:SOURce<hw>]:POWer:ALC:SONCe............................................................................ 1094
[:SOURce<hw>]:POWer:ALC[:STATe]........................................................................... 1095
[:SOURce<hw>]:POWer:ATTenuation............................................................................1095
[:SOURce<hw>]:POWer:ATTenuation:DIGital................................................................. 1096
[:SOURce<hw>]:POWer:ATTenuation:RFOFf:MODE.......................................................1096
[:SOURce<hw>]:POWer:EMF:STATe.............................................................................1096
[:SOURce<hw>]:POWer:LBEHaviour............................................................................. 1097
[:SOURce<hw>]:POWer:LIMit[:AMPLitude].....................................................................1097
[:SOURce<hw>]:POWer:LMODe................................................................................... 1097
[:SOURce<hw>]:POWer:MANual...................................................................................1098
[:SOURce<hw>]:POWer:MODE.....................................................................................1098
[:SOURce<hw>]:POWer:PEP?...................................................................................... 1099
[:SOURce<hw>]:POWer:POWer....................................................................................1099
[:SOURce<hw>]:POWer:STARt.....................................................................................1100
[:SOURce<hw>]:POWer:STOP......................................................................................1100
[:SOURce<hw>]:POWer:STEP:MODE........................................................................... 1100
[:SOURce<hw>]:POWer:STEP[:INCRement].................................................................. 1101
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:OFFSet......................................................1101
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:RCL...........................................................1102
[:SOURce<hw>]:POWer[:LEVel][:IMMediate][:AMPLitude]................................................1102
[:SOURce<hw>]:POWer:ALC:DAMPlifier <Amplifier>
Selects the driver amplifier switching state.
SOURce Subsystem