Rohde & Schwarz SMW200A - Filter Settings

Remote Control Commands
R&S
®
SMW200A
898User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:BB:DM:STANdard:ULISt:LOAD <Filename>
[:SOURce<hw>]:BB:DM:SETTing:LOAD <Filename>
Loads the selected file from the default or the specified directory. Loaded are files with
extension *.dm respectively *.dm_stu.
Refer to Chapter 13.7.2, "Accessing Files in the Default or in a Specified Directory",
on page 777 for general information on file handling in the default and a specific direc-
tory.
Setting parameters:
<Filename> string
Example: See Example "Performing general tasks" on page 891
Usage: Setting only
Manual operation: See "Save/Recall" on page 266
[:SOURce<hw>]:BB:DM:STANdard:ULISt:DELete <Filename>
[:SOURce<hw>]:BB:DM:SETTing:DELete <Filename>
Deletes the selected file from the default or specified directory. Deleted are files with
the file extension *.dm respectively *.dm_stu.
Refer to Chapter 13.7.2, "Accessing Files in the Default or in a Specified Directory",
on page 777 for general information on file handling in the default and a specific direc-
tory.
Setting parameters:
<Filename> string
Example: See Example "Performing general tasks" on page 891
Usage: Setting only
Manual operation: See "Save/Recall" on page 266
Filter Settings
[:SOURce<hw>]:BB:DM:FILTer:TYPE <Type>
The command selects the filter type.
When a standard is selected (:BB:DM:STAN), the filter type and filter parameter are
set to the default value.
Parameters:
<Type> RCOSine | COSine | GAUSs | LGAuss | CONE | COF705 |
COEQualizer | COFequalizer | C2K3x | APCO25 | SPHase |
RECTangle | USER | PGAuss | LPASs | DIRac | ENPShape |
EWPShape | LTEFilter | LPASSEVM | APCO25Hcpm |
APCO25Lsm
*RST: GAUSs
SOURce Subsystem