Rohde & Schwarz SMW200A - Signal Output Settings

Signal Routing and System Configuration
R&S
®
SMW200A
182User Manual 1175.6632.02 ─ 16
3.7.2 Signal Output Settings
Access:
► Select "I/Q Digital > I/Q Digital Settings > Signal Output".
If R&S SGT is connected to the DIG I/Q interface of the R&S SMW, "User Varia-
tion" and "Group Delay Compensation" settings are not available.
Settings:
Signal Output.............................................................................................................. 183
User Variation............................................................................................................. 183
Signal Monitoring........................................................................................................ 183
Power-On State...........................................................................................................184
Group Delay Compensation........................................................................................184
I/Q Digital Output Settings