Rohde & Schwarz SMW200A - RF Phase Settings

Configuring the Signal in the RF Domain
R&S
®
SMW200A
439User Manual 1175.6632.02 ─ 16
Variation Step ← User Variation
Sets the user-defined step width.
Remote command:
[:SOURce<hw>]:FREQuency:STEP[:INCRement] on page 1047
[:SOURce<hw>]:POWer:STEP[:INCRement] on page 1101
7.3.3 RF Phase Settings
The phase in sinusoidal signals defines the initial angle at its origin.
Access:
► Select "RF" > "RF Frequency" > "Phase".
In the "RF Phase" tab, you can determine the delta phase value and reset the
phase to this reference.
The remote commands required to define the settings are described in Chap-
ter 13.18.14, "SOURce:PHASe Subsystem", on page 1091.
Settings
Delta Phase.................................................................................................................439
Reset Delta Phase Display......................................................................................... 440
Delta Phase
Sets the phase of the RF signal.
The current phase of the signal is used as the reference.
Note: Achieving long-term stable phase-locked coupling. We recommend that you use
the LO coupling feature, if you try to synchronize the output signal with the phase of a
second signal generator for example.
See Chapter 7.5, "Local Oscillator Coupling", on page 448.
Remote command:
[:SOURce<hw>]:PHASe on page 1091
Configuring RF Frequency and Level