Rohde & Schwarz SMW200A - A.4 Revised Options Concept

Summary: New Features for R&S SMU200A Users
R&S
®
SMW200A
1183User Manual 1175.6632.02 ─ 16
Connector on
R&S SMU
Connector on
R&S SMW
Physical location on the
R&S SMW
Default assigned signal
USER with default
signal
"No Signal (Blank)",
path A
USER 5 Rear panel Output
Signal Valid A
CLOCK T/M/C 1
T/M/C 4
Rear panel
(CODER board, topmost left)
(CODER board, topmost
right)
Output
Symbol Clock A/C
Symbol Clock B/D
BBIN A DIG I/Q IN/OUT 1 Rear panel
(CODER board, topmost left)
Input
BB Input A
BBIN B DIG I/Q IN/OUT 2 Rear panel
(CODER board, topmost
right)
Input
BB Input B
BBOUT A DIG I/Q IN/OUT 1 Rear panel
(BBMM board, left part)
Output
Stream A
BBOUT B DIG I/Q IN/OUT 2 Rear panel
(BBMM board, right part)
Output
Stream B
EXT MOD EXT X Rear panel
(BBMM board)
Dedicated inputs
External analog modula-
tion signals
I/Q (analog outputs) I/Q OUT X Rear panel
(BBMM board)
Output
Stream A/B
Note: By default, the out-
put connectors are deacti-
vated
A.4 Revised Options Concept
The R&S SMW uses revised options concept.
●
The input of digital baseband signals Baseband Inputs is included in the
R&S SMW-B10, i.e. no additional option like R&S SMU-B17 is required.
The R&S SMW does not support input of analog signals in the baseband genera-
tor. Analog I/Q signals are input directly to the I/Q modulator.
●
The features of the 3GPP FDD digital standard are split into two main options, the
R&S SMW-K42 (as in R&S SMU) and one enhanced option, R&S SMW-K83.
●
The features of the IEEE 802.11 a/b/g digital standard are included in the
R&S SMW-K54 WLAN a/b/g/n, i.e. no additional option like R&S SMU-K48 is
required. The features of the IEEE 802.11 ac digital standard, however, require the
additional option R&S SMW-K86.
Revised Options Concept