Remote Control Commands
R&S
®
SMW200A
905User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:BB:DM:PRAMp[:STATe] <State>
Enables or disables power ramping.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Enable power ramping" on page 893
Options: R&S SMW-B10
Manual operation: See "State" on page 278
Trigger Settings
[:SOURce<hw>]:BB:DM[:TRIGger]:SEQuence <Sequence>
Selects the trigger mode. For detailed description of the trigger modes, refer to "Impact
of the Trigger Modes on the Signal Generation" on page 239.
Parameters:
<Sequence> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
*RST: AUTO
Example: See Example "Adjusting clock, marker and trigger settings"
on page 892
Manual operation: See "Trigger Mode" on page 255
[:SOURce<hw>]:BB:DM:TRIGger:SOURce <Source>
Selects the trigger signal source and determines the way the triggering is executed.
Provided are:
●
Internal triggering by a command (INTernal)
●
External trigger signal via one of the local or global connectors
– EGT1|EGT2: External global trigger
– EGC1|EGC2: External global clock
– ELTRigger: External local trigger
– ELCLock: External local clock
●
Internal triggering by a signal from the other basebands (INTA|INTB)
●
In master-slave mode, the external baseband synchronization signal (BBSY)
●
OBASeband|BEXTernal|EXTernal: Setting only
Provided only for backward compatibility with other Rohde & Schwarz signal gener-
ators.
The R&S SMW accepts these values and maps them automatically as follows:
EXTernal = EGT1, BEXTernal = EGT2, OBASeband = INTA or INTB
(depending on the current baseband)
SOURce Subsystem
To Next Page
Loading...
