Configuring the Internal Baseband Source
R&S
®
SMW200A
255User Manual 1175.6632.02 ─ 16
You can access and configure the common trigger source and trigger mode settings in
any of the basebands. An arm or a restart trigger event applies to all basebands, too.
You can still apply different delay to each of the triggers individually.
Trigger Mode ← Trigger Settings Common to All Basebands
Selects a regular trigger signal: "Auto", "Retrigger", "Armed_Auto", "Armed_Retrigger",
or "Single".
Refer to "Impact of the Trigger Modes on the Signal Generation" on page 239 for a
detailed description of the provided trigger modes.
Remote command:
[:SOURce<hw>]:BB:DM[:TRIGger]:SEQuence on page 905
[:SOURce<hw>]:BB:ARBitrary[:TRIGger]:SEQuence on page 954
[:SOURce<hw>]:BB:MCCW[:TRIGger]:SEQuence on page 998
Trigger Signal Duration ← Trigger Settings Common to All Basebands
Enters the length of the signal sequence to be output in the "Single" trigger mode.
Use this parameter to output part of the signal deliberately, an exact sequence of the
signal, or a defined number of repetitions of the signal.
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:SLENgth on page 906
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SLUNit on page 955
[:SOURce<hw>]:BB:MCCW:TRIGger:SLENgth on page 997
Running/Stopped ← Trigger Settings Common to All Basebands
With enabled modulation, displays the status of signal generation for all trigger modes.
●
"Running"
The signal is generated; a trigger was (internally or externally) initiated in triggered
mode.
●
"Stopped"
The signal is not generated and the instrument waits for a trigger event.
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:RMODe? on page 906
[:SOURce<hw>]:BB:ARBitrary:TRIGger:RMODe? on page 954
[:SOURce<hw>]:BB:MCCW:TRIGger:RMODe? on page 997
Arm ← Trigger Settings Common to All Basebands
Stops the signal generation until subsequent trigger event occurs.
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:ARM:EXECute on page 907
[:SOURce<hw>]:BB:ARBitrary:TRIGger:ARM:EXECute on page 955
[:SOURce<hw>]:BB:MCCW:TRIGger:ARM:EXECute on page 995
Execute Trigger ← Trigger Settings Common to All Basebands
For internal trigger source, executes trigger manually.
Common Functions and Settings in the Baseband Domain
To Next Page
Loading...
