Rohde & Schwarz SMW200A - Page 1012

Remote Control Commands
R&S
®
SMW200A
997User Manual 1175.6632.02 ─ 16
Parameters:
<Inhibit> integer
Range: 0 to 67108863
*RST: 0
Example: See "Programming Examples" on page 983
Manual operation: See "External / Trigger Inhibit" on page 257
[:SOURce<hw>]:BB:MCCW:TRIGger:RMODe?
Queries the status of signal generation for all trigger mode, if multi-carrier CW genera-
tion is on.
Return values:
<RMode> STOP | RUN
Example: See "Programming Examples" on page 983
Usage: Query only
Manual operation: See "Running/Stopped" on page 255
[:SOURce<hw>]:BB:MCCW:TRIGger:SLENgth <SLength>
Defines the length of the signal sequence to be output in the "Single" trigger mode.
Parameters:
<SLength> integer
Range: 1 to 1000
*RST: 1
Default unit: samples
Example: See "Programming Examples" on page 983
Manual operation: See "Trigger Signal Duration" on page 255
[:SOURce<hw>]:BB:MCCW:TRIGger:SOURce <Source>
Selects the trigger signal source and determines the way the triggering is executed.
Provided are:
●
Internal triggering by a command (INTernal)
●
External trigger signal via one of the local or global connectors
– EGT1|EGT2: External global trigger
– EGC1|EGC2: External global clock
– ELTRigger: External local trigger
– ELCLock: External local clock
●
Internal triggering by a signal from the other basebands (INTA|INTB)
●
In master-slave mode, the external baseband synchronization signal (BBSY)
●
OBASeband|BEXTernal|EXTernal: Setting only
SOURce Subsystem