Rohde & Schwarz SMW200A - Page 1011

Remote Control Commands
R&S
®
SMW200A
996User Manual 1175.6632.02 ─ 16
Example: See "Programming Examples" on page 983
Usage: Event
Manual operation: See "Arm" on page 255
[:SOURce<hw>]:BB:MCCW:TRIGger:EXECute
Executes a trigger.
Example: See "Programming Examples" on page 983
Usage: Event
Manual operation: See "Execute Trigger" on page 255
[:SOURce<hw>]:BB:MCCW:TRIGger:EXTernal:SYNChronize:OUTPut <Output>
Enables signal output synchronous to the trigger event.
Parameters:
<Output> 0 | 1 | OFF | ON
*RST: 1
Example: See "Programming Examples" on page 983
Manual operation: See "Sync. Output to External Trigger/Sync. Output to Trigger"
on page 256
[:SOURce<hw>]:BB:MCCW:TRIGger:OBASeband:DELay <Delay>
Specifies the trigger delay for external triggering.
Parameters:
<Delay> float
Range: 0 to 2147483647
Increment: 0.01
*RST: 0
Default unit: samples
Example: See "Programming Examples" on page 983
Manual operation: See "(Specified) External Delay/(Specified) Trigger Delay"
on page 257
[:SOURce<hw>]:BB:MCCW:TRIGger:OBASeband:INHibit <Inhibit>
Specifies the number of samples by which a restart is inhibited following a trigger event
from the other path.
SOURce Subsystem