Remote Control Commands
R&S
®
SMW200A
931User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate:NAMed <Filename>
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate:NAMed <Filename>
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed <Filename>
Generates a signal and saves it to a waveform file.
Setting parameters:
<Filename> string
Example: See Example "Creating test signals" on page 920
Usage: Setting only
Manual operation: See "Generate Signal HD" on page 312
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate
Generates a signal and uses it as output straight away.
Example:
see Example "Creating test signals" on page 920
Usage: Event
Manual operation: See "Generate Signal RAM" on page 312
Waveform Commands
The following rule applies for all commands described in this section.
By default, the waveform files are saved in the default directory of the instrument, that
is the /var/user/ directory or the directory specified with the command :MMEMory:
CDIRectory. To access the waveform files in this default directory, only the file name
is required, without the path and the file extension (*.wv).
However, to access waveform files located in a directory different to the default one,
the complete file path and file name are required.
[:SOURce<hw>]:BB:ARBitrary:WAVeform:CATalog?
Reads out the files extension *.wv in the default directory.
Return values:
<Catalog> string
Returns a list of the file names separated by commas
Example: see Example "Managing waveform files" on page 920
Usage: Query only
SOURce Subsystem
To Next Page
Loading...
