Rohde & Schwarz SMW200A - Multi-Segment Waveform Sequencing

Configuring the Internal Baseband Source
R&S
®
SMW200A
337User Manual 1175.6632.02 ─ 16
"Ignore"
The marker information carried in the individual segment waveform
files is not considered.
"Take Over"
The output waveform file contains the marker information as config-
ured in the individual waveform files.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:MODE
on page 939
Sequence Restart
Enables/disables the generation of an extra restart marker in the output waveform file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered, see also Chapter 4.8.2.4, "Impact of the
Marker Settings", on page 326.
"Disable"
No additional marker is generated.
"Marker 1, 2, 3"
Generates a restart marker signal at the beginning of the first seg-
ment of the complete multi-segment sequence.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:FSEGment
on page 939
Segment Restart
Enables/disables the generation of an extra restart marker in the output waveform file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered, see also Chapter 4.8.2.4, "Impact of the
Marker Settings", on page 326.
"Disable"
No additional marker is generated.
"Marker 1, 2, 3"
Generates a restart marker signal at the beginning of each segment.
The segment begin is defined by the low-high slope of the marker sig-
nal. This applies for switching between two segments and if there is a
segment replay.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:ESEGment
on page 939
4.8.3.4 Multi-Segment Waveform Sequencing
Access:
1. Select "Baseband > ARB > General > Multi Segment".
2. In the "ARB: Multi Segment > General" dialog, select an existing list.
3. Select "ARB: Multi Segment > Segment Table" and configure a waveform with
more than one segment.
Generating Multi-Segment Waveform Files