Remote Control Commands
R&S
®
SMW200A
939User Manual 1175.6632.02 ─ 16
Setting parameters:
<FilenameInput> string
Absolute file path, file name of the configuration file and file
extension (*.inf_mswv)
Example: See Example "Creating a multi-segment waveform" on page 922
Usage: Setting only
Manual operation: See "Save List/Save List As..." on page 332
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:MODE
<Mode>
Defines the way the marker information within the separate segments is processed.
Parameters:
<Mode> IGNore | TAKE
*RST: TAKE
Example: see Example "Adding extra marker signals" on page 926
Manual operation: See "Segment Marker" on page 336
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:ESEGment
<Mode>
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:FSEGment
<Mode>
Enables/disables the generation of an additional marker restart signal at the beginning
of the first segment (FSEGment) or at the beginning of each segment (ESEGment).
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
Parameters:
<Mode> OFF | MRK1 | MRK2 | MRK3 | MRK4
*RST: OFF
Example: see Example "Adding extra marker signals" on page 926
Manual operation: See "Sequence Restart" on page 337
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SMODe <SMode>
Selects the extended trigger mode for multi segment waveforms.
Parameters:
<SMode> SAME | NEXT | SEQuencer | NSEam
NSEam = Next Segment Seamless
*RST: NEXT
Example: see Example "Configuring the output order of the segments"
on page 924
SOURce Subsystem
To Next Page
Loading...
