Rohde & Schwarz SMW200A - Format Subsystem

Remote Control Commands
R&S
®
SMW200A
801User Manual 1175.6632.02 ─ 16
Setting parameters:
<DialogId> string
To find out the dialog identifier, use the query :DISPlay:
DIALog:ID?.
The <DialogName> part of the query result is sufficient.
Example: See Example "Querying the dialog IDs, opening and closing dia-
logs" on page 797
Usage: Setting only
:DISPlay:DIALog:CLOSe:ALL
Closes all open dialogs.
Example:
See Example "Querying the dialog IDs, opening and closing dia-
logs" on page 797
Usage: Event
13.12 FORMat Subsystem
The commands in the FORMat subsystem determine the format of data returned by the
R&S SMW to the controller. This affects all query commands that return a list of
numerical data or block data, noted in the descriptions of the commands. The set data
format applies to both paths.
:FORMat:BORDer..........................................................................................................801
:FORMat:SREGister.......................................................................................................802
:FORMat[:DATA]............................................................................................................802
:FORMat:BORDer <Border>
Determines the sequence of bytes within a binary block. This only affects blocks which
use the IEEE754 format internally.
Parameters:
<Border> NORMal | SWAPped
NORMal
Expects/sends the least significant byte of each IEEE754 float-
ing-point number first and the most significant byte last.
SWAPped
Expects/sends the most significant byte of each IEEE754 float-
ing-point number first and the least significant byte last.
*RST: NORMal
Example:
FORM:BORD SWAP
transfers the data with the most significant bit first.
FORMat Subsystem