Rohde & Schwarz SMW200A - Level; Clock; Marker Settings

Configuring the Internal Baseband Source
R&S
®
SMW200A
335User Manual 1175.6632.02 ─ 16
"Clock Rate"
Selects the clock rate of the blank segment.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:BLANk:APPend
on page 940
"Samples"
Selects the number of samples for the blank segment.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:BLANk:APPend
on page 940
"Period"
Displays the resulting period for the blank segment.
"Append
Blank"
Adds the blank segment to the multi-segment file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:BLANk:APPend
on page 940
4.8.3.3 Level / Clock / Marker Settings
Access:
1. Select "Baseband > ARB > General > Multi Segment".
2. In the "ARB: Multi Segment > General" dialog, select an existing list.
3. Select "ARB: Multi Segment > Segment Table" and configure the segments.
4. Select "ARB: Multi Segment > Level/Marker/Clock".
The "Level/Marker/Clock" tab provides the parameters necessary to adjust the
level, marker and clock settings for the selected multi-segment waveform file.
Settings:
Level............................................................................................................................336
Clock........................................................................................................................... 336
User Clock Rate..........................................................................................................336
Generating Multi-Segment Waveform Files