Rohde & Schwarz SMW200A - List Editor

Configuring the Signal in the RF Domain
R&S
®
SMW200A
532User Manual 1175.6632.02 ─ 16
User Cor. Data
Accesses the standard "File Select" function of the instrument. The provided navigation
possibilities in the dialog are self-explanatory.
Files with user correction values are files with predefined file extension *.ucor. When
a file is selected, the dialog indicates the filename.
You can create the file internally in the table editor or externally.
●
To select an existing file, select "Select List > navigate to the file *.ucor > Select"
●
Use the general editor function to create internally new file or to edit an existing
one.
●
Use the standard file manager function to load externally created files to the instru-
ment.
Remote command:
[:SOURce]:CORRection:CSET:CATalog? on page 1031
[:SOURce<hw>]:CORRection:CSET[:SELect] on page 1029
[:SOURce]:CORRection:CSET:DELete on page 1031
Edit User Cor. Data
Opens the build-it table editor to define a new correction table or edit an existing one.
See also:
●
Chapter 7.6.7, "List Editor", on page 486
●
" Fill Table Automatically " on page 488
●
Chapter 7.8.3.3, "Fill with Sensor", on page 535
7.8.3.2 List Editor
The "User Correction" and "List Mode" dialogs provide a build-in list editor for defining
frequency/level value pairs.
Since the table and navigation functions can be assumed to be known, the following
description contains a brief overview, shown by the example of the "List Data Editor". If
a function relates to a particular dialog, it is explicitly stated.
Access:
1. "RF" > "Sweep/List" > "List Mode" > "List Mode Data" > "Edit List Mode Data"
Improving Level Performance