Rohde & Schwarz SMW200A - Source:bb:arbitrary Subsystem

Remote Control Commands
R&S
®
SMW200A
919User Manual 1175.6632.02 ─ 16
Return values:
<Tag> <control list>,<tag name>
Refer to "Tag Description" on page 962 for description of the
available tag formats.
Example:
SOURce1:BB:DM:DLISt:TAG? "D_list","date"
Queries the Date tag in list D_list.
Usage: Query only
13.18.4.3 SOURce:BB:ARBitrary Subsystem
This section list the commands of the SOURce:BB:ARBitrary subsystem.
Suffixes in the keywords ENTity<ch> and SOURce<hw>
You can address multiple entities configurations by using the SCPI commands starting
with the keyword SOURce or the alias commands starting with the keyword ENTity.
Table 13-6: Value ranges of the suffixes ENTity<ch> and SOURce<hw> in advanced configuration
with multiple entities
SCPI Syntax
ENTity<ch> SOURce<hw>
SOURce<hw>:BB:...
- 1 .. 8
ENTity<ch>:SOURce<hw>:BB:...
1 1 .. 8
2 .. 4 1 .. 4
See also Chapter 13.3, "SCPI Command Aliases for Advanced Mode with Multiple
Entities", on page 767.
Required options
See Chapter 4.7.1, "Required Options", on page 300.
The commands are grouped in the following sections:
● Programming Examples........................................................................................920
● General Commands..............................................................................................928
● Test Signal Commands.........................................................................................928
● Waveform Commands.......................................................................................... 931
● Multi-Segment Commands....................................................................................936
● Multi-Segment Sequencing Commands................................................................940
● Multi-Carrier Commands.......................................................................................943
● Trigger Commands............................................................................................... 954
● Marker Commands................................................................................................959
● Clock Commands..................................................................................................961
SOURce Subsystem