Getting Started
R&S
®
SMW200A
43User Manual 1175.6632.02 ─ 16
ever, functions that concern the integration of the instrument into a measurement
setup are not changed, for example reference oscillator source settings.
●
Preset of the instrument to its factory settings
The instrument can also be forced to load its default factory settings, except that
the security settings are not affected. To access the corresponding dialog box,
select the "Taskbar > System Config > Setup > Settings > Factory Preset" function.
For more information and an overview of the settings affected by the factory preset
function, see Chapter 10.2, "Restoring the (Default) Instrument Configuration",
on page 622.
User-defined instrument states can be stored and called up using the "Setup > Save/
Recall" function or the SAVE/RCL key.
2.1.1.9 Checking the Supplied Options and Licenses
The instrument can be equipped with both, hardware and firmware options. To check
whether the installed options correspond to the options indicated on the delivery note,
proceed as follows:
1. Press the SETUP key.
2. Select "Instrument Assembly > Hardware Config" and "Software / Options".
A list with hardware and firmware information is displayed.
3. Check the availability of the hardware options as indicated in the delivery note.
For an overview of the available options, refer to the data sheet.
See also Chapter 14.3.8, "Requesting Instrument Configuration and Specifications",
on page 1167.
2.1.2 Linux Operating System
The instrument uses an embedded Linux operating system, optimally adapted to the
signal generator.
Accessing the operating system
No access to the operating system is required for normal operation.
All necessary system settings can be made in the "Setup" dialog.
The R&S SMW provides an internal hard disk drive. The hard disk holds the operating
system, the firmware, and the stored data. The folder /var/user and all subfolders
can be used to store user data.
Preparing for Use
To Next Page
Loading...
