Rohde & Schwarz SMW200A - I;Q Analog Output Settings

Signal Routing and System Configuration
R&S
®
SMW200A
185User Manual 1175.6632.02 ─ 16
3.8 I/Q Analog Output Settings
Required Options
The equipment layout for output of analog I/Q signal includes:
●
Option Standard Baseband Generator (R&S SMW-B10) per signal path and
Option Baseband main module, one/two I/Q paths to RF (R&S SMW-B13/-B13T)
Incl. output the baseband signal at the single-ended outputs
●
Option Differential Analog I/Q Outputs (R&S SMW-K16) per signal path
Or
●
Option Wideband Baseband Generator (R&S SMW-B9) per signal path and
Option Wideband baseband main module two I/Q paths to RF (R&S SMW-B13XT)
Incl. output the baseband signal at the single-ended outputs
●
Option Wideband Differential Analog I/Q Outputs (R&S SMW-K17)
One differential output; differential and single-ended signals cannot be output at
the same time.
Access
The analog output connectors I/Q x are located on the R&S SMW rear panel, see Fig-
ure 3-2.
The block diagram displays the "I/Q OUT 1/2" connector in a folded state. The analog
output connectors are inactive (gray LEDs).
Figure 3-13: Representation of the analog output interface
1 = analog output interface state: gray = inactive; blue = active
2 = mapped I/Q stream
3 = analog output connector name
To access and configure the "I/Q Analog Output" settings
1. Select the "I/Q OUT 1/2" symbol to unfold the "I/Q Analog" block.
2. To (re) route the signal to the analog outputs, select the "I/Q Stream Mapper"
block.
3. To enable the baseband signal at the analog outputs, select "Block Diagram > I/Q
Analog A or B > I/Q Analog On".
4. To access the dialog box for configuring the analog output signal, select "I/Q Ana-
log > I/Q Analog Settings > General".
I/Q Analog Output Settings