Signal Routing and System Configuration
R&S
®
SMW200A
131User Manual 1175.6632.02 ─ 16
Figure 3-1: Location of the digital input and output interfaces (part view of the rear panel of a
fully equipped instrument)
●
The Figure 3-2 shows the analog output interfaces on the rear panel together with
the associated GUI term (highlighted in orange color).
Figure 3-2: Location of the analog output interfaces (part view of the rear panel of a fully equip-
ped instrument)
Direction of the digital interface
Each of the six connectors serves as an input or an output connector. The selected
fading and baseband configuration automatically predefines the direction of the
required connectors (see "System Configuration LxMxN" on page 141).
If you change these predefined settings, cross-check the direction of the digital inter-
face before you connect an external instrument.
See:
●
"To find out the correct connector" on page 192 and "Indication of the digital inter-
face status" on page 132
●
"To find out the connector's direction" on page 193
(if you operate the instrument remotely)
Overview of the Input and Output Signals and Interfaces
To Next Page
Loading...
