Rohde & Schwarz SMW200A - Marker Settings

Remote Control Commands
R&S
®
SMW200A
999User Manual 1175.6632.02 ─ 16
Parameters:
<Sequence> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
*RST: AUTO
Example: See "Programming Examples" on page 983
Manual operation: See "Trigger Mode" on page 255
Marker Settings
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:MODE.................................................999
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:ONTime.............................................. 999
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:OFFTime.............................................999
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PATTern........................................... 1000
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:DIVider.................................. 1000
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:FREQuency?..........................1000
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay...............................................1000
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:MODE <Mode>
Defines the signal for the selected marker output. For detailed description of the regu-
lar marker modes, refer to "Marker Modes" on page 235.
Parameters:
<Mode> RESTart | PULSe | PATTern | RATio
*RST: RESTart
Example: See "Programming Examples" on page 983
Manual operation: See "Marker Mode" on page 259
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:ONTime <OnTime>
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:OFFTime <OffTime>
Sets the number of samples in the off period of the corresponding marker signal.
*)
If R&S SMW-B9 is installed, the minimum marker duration depends on the sample/
symbol rate.
See "Marker Minimum Duration" on page 236.
Parameters:
<OffTime> integer
Range: 1 (R&S SMW-B10) / 16* (R&S SMW-B9) to
16777215
*RST: 1
Example: see "Programming Examples" on page 983
Manual operation: See "Marker Mode" on page 259
SOURce Subsystem