Rohde & Schwarz SMW200A - Page 274

Configuring the Internal Baseband Source
R&S
®
SMW200A
259User Manual 1175.6632.02 ─ 16
Settings:
Marker Mode...............................................................................................................259
Marker x Delay............................................................................................................260
Marker Mode
Basic marker configuration for up to three marker channels. The contents of the dialog
change with the selected marker mode.
Use the settings to define the shape and periodicity of the markers. See Chap-
ter 4.5.1.2, "Regular Marker Output Signals", on page 234 for description of the regular
marker signals.
The instrument routes the generated marker signals to the selected output connectors,
see Chapter 11.2, "Configuring the Local and Global Connectors", on page 661.
"CList"
A marker signal as defined in the selected control list.
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:MODE on page 910
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PULSe:DIVider on page 911
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PULSe:FREQuency?
on page 911
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PATTern on page 911
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:OFFTime on page 910
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:ONTime on page 910
ARB: see "Marker Mode" on page 315
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:MODE on page 999
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:DIVider on page 1000
Common Functions and Settings in the Baseband Domain