Configuring the Internal Baseband Source
R&S
®
SMW200A
223User Manual 1175.6632.02 ─ 16
●
Wideband signals also in the microwave range
Where to find related information
This description assumes a fully equipped Standard baseband R&S SMW, so that we
can explain all instrument concepts and show the possible configuration and settings. If
a particular function requires a special option, this option is stated in the list of the
required options.
If your instrument is equipped with Wideband baseband generator, some sections of
this description are not relevant. For an overview of the related sections, see Chap-
ter 1.5.2, "Wideband Baseband Generator Related Settings and Descriptions",
on page 34.
4.3 How to Access the Functions in the Baseband
Domain
To access the functions of the baseband generator
1. In the block diagram, select the corresponding "Baseband" block and navigate
through the context menu.
The "Baseband" block comprises all functions and settings concerning the base-
band signal. These include all generation modes, as described in the Chapter 4.1,
"Overview of the Signal Generation Modes", on page 220.
2. The signal generation is not started immediately.
To activate the baseband generator: in the block diagram, select the corresponding
"Baseband" block and set "Baseband > On".
A short designation indicates the digital standard or modulation currently selected.
How to Access the Functions in the Baseband Domain
To Next Page
Loading...
