Rohde & Schwarz SMW200A - Analog and Digital Impairments Settings

Simulating Fading, Adding Noise and Predistortions, and Impairing the Signal
R&S
®
SMW200A
409User Manual 1175.6632.02 ─ 16
5.3.3 Analog and Digital Impairments Settings
You can add digital impairments to each internal generated I/Q stream and analog
impairments to internal generated or external supplied analog I/Q signals
See also Chapter 5.3.2, "About the Linear I/Q Impairments", on page 406.
1. To access the dialog with settings for the analog I/Q signal, select "I/Q Mod > Ana-
log Impairments".
The dialog covers the settings for I/Q impairment, like carrier leakage, imbalance
and quadrature offset.
2. To access the dialog with settings for the corresponding digital I/Q impairments,
select one of the following:
● Select "I/Q Mod > Digital Impairments"
● Select "I/Q Analog > Digital Impairments"
● Select "I/Q Digital > Digital Impairments"
Impairing the Signal