Rohde & Schwarz SMW200A - Remote Control States

Network Operation and Remote Control
R&S
®
SMW200A
765User Manual 1175.6632.02 ─ 16
#NO_COMMAND_CODE_START
//no SCPI command available for parameter %PARAMETER !
#NO_COMMAND_CODE_END
#EXIT_CODE_START
viClose (handle);
viClose (defaultRM);
return 0;
}
#EXIT_CODE_END
12.18.3 Remote Control States
How to I recognize if there is an active remote connection to the instrument?
► Observe the indication on the taskbar.
A softkey in the taskbar indicates if and what kind of remote connections are cur-
rently set up.
See also Chapter 12.4.6, "Active Connections Settings", on page 721.
The following table shows the different remote control states and the associated com-
mands or actions to return to manual control.
Table 12-3: Remote control status icons
GUI symbol Transition to remote control state... Transition to manual operation...(local state)
&GTR (controller)
Remote control, but usable front panel keys.
The parameters are in read-only mode.
●
&GTL (controller)
●
Tap the "Remote" icon (display)
●
LOCAL (front panel or key emulation)
A currently performed setting is indicated by the green
arrows.
The setting must be completed (white arrows), other-
wise the instrument remains in remote state.
&LLO (controller)
Remote control with locked front panel keys to
prevent user interaction.
The parameters are in read-only mode.
You can unlock LLO, and thus return to manual
operation only via remote control.
●
&LOCS (controller)
●
CALL IBLOC (generator%) (controller)
Note: The command &REMS returns to "Remote" state.
References