Rohde & Schwarz SMW200A - General Settings

Signal Routing and System Configuration
R&S
®
SMW200A
172User Manual 1175.6632.02 ─ 16
Figure 3-9: Example: "Baseband Input Settings" in 2x2x2 System Configuration
If the current instrument configuration uses Coupled sources, the dialog consists of
up to four side tabs, whereas the number of tabs corresponds to the number of
selected BB Signals (Tx Antennas). The tab name displays the baseband the set-
tings are related to and the connector the digital input signal is provided at.
5. To enable the input signal:
● select "BB Input > On" or
● select "BB Input > Baseband Input Settings > State > On".
The remote commands required to define these settings are described in Chap-
ter 13.18.2, "SOURce:BBIN Subsystem", on page 864.
Settings:
● General Settings................................................................................................... 172
● Sample Rate Settings........................................................................................... 173
● Input Level Settings...............................................................................................175
● Signal Monitoring Settings.................................................................................... 176
3.6.1 General Settings
Access:
► Select "BB Input > Digital I/Q In > Baseband Input Settings".
Digital Baseband Input Settings