Remote Control Commands
R&S
®
SMW200A
774User Manual 1175.6632.02 ─ 16
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC).
Usage: Event
13.6 Preset Commands
The preset commands are not bundled in one subsystem. Therefore, they are listed
separately in this section. In addition, a specific preset command is provided for each
digital standard and for the fader. These specific commands are described in the asso-
ciated subsystems.
Four presetting actions are available:
●
Activating the default state of all internal instrument functions (*RST on page 772).
Functions that concern the integration of the instrument into a measurement setup
are not changed, e.g. GPIB address or reference oscillator source settings.
●
Activating the preset state of the parameters related to the selected signal path (:
SOURce<hw>:PRESet on page 774)
●
Activating the preset state of all parameters that are not related to the signal path
(:DEVice:PRESet on page 774)
●
Activating the original state of delivery (factory reset, :SYSTem:FPReset
on page 775). Only functions that are protected by a password remain
unchanged as well as the passwords themselves.
:DEVice:PRESet............................................................................................................ 774
:SOURce<hw>:PRESet.................................................................................................. 774
:SYSTem:PRESet..........................................................................................................775
:SYSTem:FPReset.........................................................................................................775
:DEVice:PRESet
Presets all parameters which are not related to the signal path, including the LF gener-
ator.
Example:
DEV:PRES
Presets all instruments settings that are not related to the signal
path.
Usage: Event
Manual operation: See "Connect/Disconnect All Remote" on page 149
:SOURce<hw>:PRESet
Presets all parameters which are related to the selected signal path.
Fading simulator (if available) and the transient recorder are only preset by command
*RST.
Preset Commands
To Next Page
Loading...
