Getting Started
R&S
®
SMW200A
67User Manual 1175.6632.02 ─ 16
2.3.1 Generating an Unmodulated Carrier
We start out by generating a simple unmodulated signal. The R&S SMW in this exam-
ple can be a base unit in its minimal configuration.
1. On the R&S SMW front panel, press the PRESET key to start out in a defined
instrument configuration.
2. Set the frequency:
a) On the "Status Bar", tap the "A Freq" field.
b) On the on-screen keypad, enter 1.955 and press the "GHz" key.
The on-screen key pad closes and the frequency value is displayed.
3. On the "Status Bar", tap the "Lev" field and enter the level in the same way.
4. Select "Block Diagram > RF A Block > On" to enable the output of the generated
unmodulated signal.
Trying Out the Instrument
To Next Page
Loading...
