Rohde & Schwarz SMW200A - Noise Power;Output Results Settings

Simulating Fading, Adding Noise and Predistortions, and Impairing the Signal
R&S
®
SMW200A
398User Manual 1175.6632.02 ─ 16
5.2.3.2 Noise Power/Output Results Settings
Access:
► Select "AWGN > Noise Power/Output Results".
The available settings depend on the selected Mode.
Settings:
Show Powers for Output............................................................................................. 399
Connected Instrument.................................................................................................399
Set Noise Power Via................................................................................................... 399
Reference Mode..........................................................................................................399
Bit Rate....................................................................................................................... 400
Carrier/Noise Ratio, Signal/Noise Ratio...................................................................... 400
E
b
/N
0
............................................................................................................................400
Carrier Power, Signal Power.......................................................................................401
Noise Power (System Bandwidth), Interferer Power...................................................401
Noise Power (Total Bandwidth)...................................................................................402
Adding Noise to the Signal