Getting Started
R&S
®
SMW200A
109User Manual 1175.6632.02 ─ 16
1 = Frequency display
2 = Status buttons
3 = Level display
The status buttons indicate key parameters that are set for the output signal. Most of
the status buttons are virtual keys you can use to open a corresponding menu or dia-
log.
Underlined names, such as , , or (in the block diagram) are also touch-sensi-
tive. By touching them, you can execute a setting or access the dialog or menu.
For an overview of the status buttons and their functionality, refer to Chapter D, "Ele-
ments and Controls of the Graphical User Interface", on page 1223.
2.5.3.2 Block Diagram
The block diagram shows the current configuration and the signal flow in the generator
with the aid of function blocks, connected by signal lines. The following figure displays
almost all the elements that can appear in the block diagram. However, it does not
necessarily represent a useful configuration.
1
= Status indicator
2 = Functional block
3a / 3b = Control signal block
4 = Signal line (digital)
5a / 5b = Graphics indicator
6 = Signal line (analog)
7a / 7b / 7c / 7d / 7e = Connector icons (RF, analog, digital)
8 = Stream indicator
9a / 9b = Stream status indicator (On/Off)
10a / 10b = Stream indicator (Single, Add)
Instrument Control
To Next Page
Loading...
