General Instrument Functions
R&S
®
SMW200A
688User Manual 1175.6632.02 ─ 16
The remote commands required to unlock a protected stage are described in Chap-
ter 13.19, "SYSTem Subsystem", on page 1115.
Protection Level/Password
Unlocks the selected level of protection, if you enter the correct password.
The default protection level 1 password is 123456.
To lock the protection level again, clear the checkbox.
Remote command:
:SYSTem:PROTect<ch>[:STATe] on page 1122
11.5.2 Setting Security Parameters
Access:
► Select "System Config > Setup > Security > General".
In the "Security" dialog, you can configure the mass storage security settings.
The settings in this dialog are not applied until you enter the Security Password and
confirm with Accept.
Managing the Security Settings
To Next Page
Loading...
